 |
| Cutting outer wing spars to length |
We continue to biscuit and glue sleeves into the main wing spar parts. We're also starting to assemble the Prop Shaft Assembly, starting with the Prop Shaft Rear part, gluing in Titanium bearing seats and stiffening biscuits (both balsa-faced and carbon fiber faced).
 |
| Preparing to mark a spar |
 |
| Marking biscuit location on a wing spar |
 |
| Prepping a wing spar sleeve for gluing |
 |
| Three spar segments connected together during glue drying (20 meters long) |
 |
| Another view of 3 spar segments together |
 |
| Applying glue to a Medium-to-Outer wing spar sleeve |
 |
| Gluing the sleeve into a spar |
 |
| Prepping the biscuits on the Fuse Tube (part of Prop Shaft assy) for gluing |
 |
| Gluing the Fuse Tube into the fuselage Top Tube |
 |
| Biscuiting a spar segment |
 |
| Glue pooling at the bottom of the end biscuit in the Tail Boom |
 |
| Angling wing spar and tail boom to allow pooling glue on biscuits to flow towards biscuit edge |
 |
| Making a carbon fiber faced biscuit |
 |
| Clamping a CF-faced biscuit |
 |
| A cool view down the Prop Shaft Rear part of the Titanium Front Bearing Seat |
 |
| Applying glue into the Prop Shaft Rear part to glue a biscuit |
 |
| Glue before biscuit is pushed into place |
 |
| Prepping a center wing rib section for lamination |
No comments:
Post a Comment